We utilize a number of belt mounting systems on our products to secure them to a belt.  These belt mounting systems are used on products such as defense spray, magazine, and baton carriers. Some of the mounting systems were designed for a specific product, where others are used with multiple items. Therefore it is important to understand that:

NOT ALL MOUNTING SYSTEMS ARE AVAILABLE FOR ALL PRODUCTS.

Refer to the diagrams below and the following descriptions for each belt mounting system:




BELT MOUNTING SYSTEMS


FOLDED SECURITY SNAP LOOP

On open top versions of some carriers, the leather piece that usually serves as the top flap for covered carriers is folded to the back to create a solid belt loop top and is attached at the bottom with a security snap.

FOLDED STITCH LOOP
On open top versions of some carriers, the leather piece that usually serves as the top flap for covered carriers is folded to the back to create a solid belt loop top and is attached at the bottom with stitching.

DOUBLE STITCHED LOOP
A strap of leather is stitched at each end to the body of the carrier to provide a very strong loop that will not release under pressure.

STITCHED SECURITY SNAP LOOP
A strap of leather is stitched to the top end and fastened with a security snap to the bottom end of the carrier. The security snap is designed to only release by being pulled up from the bottom. This feature enables the carrier to remain securely fastened to a belt even if pressure is applied by pulling or yanking on the carrier, yet at the same time allows the user to easily attach and remove the carrier through proper operation of the security snap.

DOUBLE STITCHED FLAP LOOP
A long leather strap is stitched in two places to the body of the carrier to form a belt loop and also folds over the top of the carrier to double as the snap flap. This creates a very strong loop that will not release under pressure.

FOLDED, STITCHED, AND RIVETED LOOP
This loop used on baton carriers is created by folding the solid leather body piece down the back of the carrier and stitching the bottom end of the loop. This loop is then made extremely secure by the addition of a rivet at the bottom of the loop.

SPRING CLIP
A metal spring clip is securely attached to the back of the carrier and provides a sturdy and quick on/off attachment. The belt clip fits belts up to 1-3/4 inch wide.

65°/90° BELT SLIDE (SL65/90)
This belt slide is designed to fit up to 2-1/4 inch belts and is made of stitched reinforced leather. It allows carriers to be mounted at 65 or 90 degree angle and is interchangeable for left or right cant. The carrier simply attaches to the belt slide using screws.

25° BELT SLIDE (SL25)
This belt slide can be made to fit 1-3/4 inch or 2-1/4 inch belts. Another reinforced leather attachment that allows carriers to be mounted at a 25 degree angle, either right or left cant..